Tuesday, 19 June 2012

UPDATE DDLC2 FOR SAMSUNG GALAXY Y


Lightbulb [Stock][ROM][Odin] Galaxy Y S5360 flashable firmware packages

READ FAQ, Q&A and Know Issues before downloading and using this packs

TESTED and WORKING ODIN FLASHABLE BUNDLES for Samsung Galaxy Y THANKS TO DOKY73 ON XDA 
:
INFORMATION : 
Since Galaxy Y has been released, there are several firmware files available from different sources, eg. sammobile and etc... But most of these firmware packages (which are original unmodified Kies files) are useless for us, because Odin is not able to flash these files.
Therefore I started to analyze the Kies pack, and finally developed a method to convert the Kies files to Odin-able package.

The full conversion process of one pack took me about 2-3 hours including download, analyze, rebuild, test, upload, and finally post. So please keep in mind, I'm not just a redistributor of the firmware files, I've real work in it. Your thanks (button) and donations are very welcome, if my work helps you anyway.
In case Your work based in my rebuilt bundles, crediting me is expected. Stealing my work is unforgivable.





HOW TO FLASH 

Flashing guide...

Before You proceed: take a notice, and record your original (in case you are on original stock fw) firmware levels by typing *#1234# and PCODE by *2767*4387264636#. This might be helpful if you want to go back to your original in-box firmware.

Check WHITE-CZ's video tutorial on the boot mode selection hints!

- download the required firmware bundle
- install Kies, or Samsung driver pack
- unzip the package, You'll get 3 *.tar (or tar.md5) files
- download Odin3 1.84 or 1.85 (click here)
- stop Kies
- stop all active ADB sessions
- start odin
- do backup of your data and apps
- charge your SGY at least 75%
- remove SGY from USB or charger
- start the pone in Download mode 

- power off Your SGY
- wait 30 sec
- Press Vol Down, Home, and Power at the same time
- When (about 5 sec) Warning screen appears, release Volume Down and Power, then (a bit later) Home
- press Vol Up (You'll get Odin mode screen)
- Browse the 3 tar files to odin PDA=PDA_xxxx.tar, PHONE=MODEM_ or PHONE_xxxxx.tar, CSC=CSC_xxxxx.tar
- no PIT and/or BOOT files required - leave it empty!
- leave all other fields and checkboxes default!
- connect your phone, You must see yellow 0:[COMxx] in the first ID:COM and "Added" in the message box
- Start flashing by the START button.
- flashing will start immediately, see the progress in the message box, and progress bar on the phone
- Wait 1-3 minutes, until green PASS! in the upper left
- SGY will reboot, leave it as is for 2-5 minutes until startup finishes
- if it stuck (eg boot anim loop) then:
- Start the phone in Recovery mode

- remove battery
- resinsert battery, wait 30 sec
- press Vol Up, Home, Power at the same time
- when Galaxy Y logo appears, release the Power button
- when Recovery menu appears, release the Home button first, then finally Vol Up 
- select wipe data/factory reset (Vol UP/Down + Home)
- select reboot system now
When Android boots up, it's highly recommended to set your CSC via the dialer *#272*_your_imei_# (to see IMEI type *#06# in dialer) -> (it will erase all your data on the phone, but not the SD card)


SCREEN SHORT:








No comments:

Post a Comment